• Table of contents
• 4. Results
  • 4.1 Preparation
  • 4.2 Trials
    • 4.2.1 Inter Frequency Spectrum with Optical Link
    • 4.2.2 Link Quality with Optical link
    • 4.2.3 Link Quality with Coaxial Cable
    • 4.2. Link Quality with Coaxial Cable

4. Results¶

This section explains how the Outdoor system has been installed and the results obtained measuring a real TV signal from a Satellite.

Optical system (transmitter + fiber + receiver)

4.1 Preparation¶

The optical transmitter has been put in an hermetic box.

Hermetic box installed outdoors

Its interface consists of :

• The power supply plug to be connected to the mains ;
• The optical fiber harness (2 fibers) : only the red fiber is actually connected to optical transmitter ; the black fiber is not used, it will enable to have a b.
• The type F coaxial cable to connect the Antenna Low Noise Block, LNB, to optical transmitter.

Optical transmitter is set to :

• To supply 18 V to LNB, which selects Horizontal polarization.
• To provide 0 kHz tone to LNB, which set its Local Oscillator to 9.75 GHz to transpose lower Ku Band from 10.7 to 11.7 GHz into IF Band.
• This hermetic box has been mounted on Antenna mast. This Antenna is pointing to Astra 1KR/1L/1M/1N co-localized satellites on 19.2° East.

Hermetic box installed on Antenna Mast

4.2 Trials¶

4.2.1 Inter Frequency Spectrum with Optical Link¶

RF output from Optical receiver has been analyzed with Rohde & Schwartz FSV spectrum analyzer :

IF Band, 1 Channel (with Optical Link)

It is possible to distinguish several channels within the Inter Frequency, IF, band. There is a zoom on left side. The 3 dB channel bandwdith is 22 MHz.
The power is about -32 dBm for the channel centered around 1141 MHz.

TV channel at 1141 MHz

4.2.2 Link Quality with Optical link¶

Measurement setup based on TV, Tuner, IPRICOT SCB router with Optical Receiver (On screen : Einsfestival program on 10744 MHz Horizontal Polarization)

First, optical link performance enables to have a good TV quality (for example, Einsfestival Plus on 10744H).

Channel power and 3 dB Channel bandwidth have been checked with Spectrum Analyzer.

More deeply, physical link quality has been assessed with the information provided by IPRICOT SCB router :

• IPRICOT confirms that input signal is a QPSK modulation with Forward Error Correction Rate of 5/6 (RX_SIG & VITSYNC set to green). Moreover, IPRICOT is able to get the Frame Synchronization (FSYNC set to green) ;
• Eb/No is reported by IPRICOT.

This data has been compared with data from website like [www.lingsat.com] :

Ku Channel [MHz]	IF Channel [MHz]	TV	www.lingsat.com		Spectrum Analyzer		IPRICOT
		Channel	Physical Protocol	EIRP[dBW]	3dB CH BW [MHz]	3dB CH Power [dBm]	Physical Protocol	Eb/No[dB]
10744H	994	Eins Plus	DVB-S QPSK 22 Msps 5/6		About 22	-31.94	DVB-S QPSK 22 Msps 5/6	7.7
11244H	1494	Schau TV	DVB-S QPSK 22 Msps 5/6		About 22	-32.81	DVB-S QPSK 22 Msps 5/6	7.9

Physical link parameter at 10744 MHz

4.2.3 Link Quality with Coaxial Cable¶

Optical link have been replaced by coaxial cable. Similar measurements have been carried out.

Spectrum at 944 MHz (related to 10744 MHz H)

Physical link parameter at 10744 MHz

4.2. Link Quality with Coaxial Cable¶